Molded Cranberry Sauce
Food
Audio By Carbonatix
By Aimee McCullough, Editor in Chief
Molded Cranberry Sauce
Serves 12-14
From Williams-Sonoma
Ingredients:
- 1 1/4 lbs fresh cranberries
- 1 1/3 cups sugar
- 2 tsp. orange zest
- 3/4 cup plus 2 Tbs. fresh orange juice
- Pinch of salt
- 1 cup water
- 1 Tbs. unflavored gelatin
A few notes on making this:
- I have a pretty ceramic cranberry mold I purchased years ago from Williams Sonoma and it came with this recipe—you will need a little mold or bowl in order to make this.
Directions:
- In a large saucepan over medium-high heat, combine the cranberries, sugar, orange zest, orange juice, salt and 3/4 cup plus 2 Tbs. water. Bring to a boil, then reduce the heat to medium-low and simmer, stirring occasionally, until the sauce thickens and the cranberries have burst, 25 to 35 minutes.
- Meanwhile, pour the remaining 2 Tbs. water into a bowl and sprinkle with the gelatin. Let stand until the gelatin softens and swells, 5 to 10 minutes.
- Spoon 3/4 cup of the hot juices from the cranberries into the gelatin and whisk until the gelatin has dissolved.
- Pour the gelatin mixture into the cranberry mixture and whisk to combine. Lightly coat the inside of a ceramic cranberry mold with nonstick cooking spray. Pour the cranberry mixture into the prepared mold and let cool to room temperature. Cover loosely with plastic wrap and refrigerate for at least 8 hours or up to overnight.
- To unmold, set the mold in a large bowl of warm water (115° to 120°F) so the water reaches almost to the rim of the mold. Let stand for 30 seconds, then remove the mold from the water. Carefully insert a small offset spatula or paring knife along the side of the mold. Gently pull the gelatin away from the mold to release the suction, then remove the spatula. Place a serving platter upside down on top of the mold and invert the platter and mold together. Remove the plug. Gently shake the mold until you hear the gelatin begin to release, then lift off the mold. If the gelatin does not release, replace the plug and return the mold to the warm water for 15 seconds, then repeat the steps as directed above.
